Philips DCM230/12 ユーザーズマニュアル

18

1

Press SOURCE repeatedly (or TUNER on the
remote control) to select the tuner source.

2

Press BAND on the remote control to select
the desired waveband : FM or MW.

3

Hold 

S

/

T

 (or 

5 /6

on the remote

control) and then release the button.

➜

The system will start searching for a radio

station with sufficient signal strength.

4

Repeat step 3 if necessary until you find the
desired station.

●

To tune to a weak station, press 

S

/

T

 (or

5 /6

on the remote control) briefly and

repeatedly until you have found optimal
reception.

You can store up to a total of 20 radio stations
for each band in the memory.

Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden.

1

Press ALBUM/PRESET +/- (or 

¡ / ™ on the

remote control) to select the preset number
where programming should start.

2

Press PROG for more than two seconds to
activate programming.

➜

All available stations are programmed.

1

Tune to your desired station (refer to “Tuning to
radio stations”).

2

Press PROG to activate programming.

➜

 flashes in the display.

3

Press ALBUM/PRESET +/- (or 

¡ / ™ on the

remote control) to allocate a number from 1 to
20 to this station.

4

Press PROG again to confirm the setting.

➜

 disappears, the preset number and

the frequency of the preset station are shown.

5

Repeat the above four steps to store other
stations.

●

You can override a preset station by storing
another frequency in its place.

TIMER

iPod

pg001-027_DCM230_12-Eng

8/29/08, 11:30

18