Mitsubishi Electronics DX-TL16U ユーザーズマニュアル

Digital Video Recorder 

 49

 

 

You can use a mouse for convenient PTZ control.  Position the mouse pointer at the bottom of the screen, 
and the following PTZ toolbar will display. 

 

 
 
 

 

Clicking   on the left side exits the toolbar.  If you want to display the toolbar again, position the mouse 
pointer at the bottom of the screen.  Change the toolbar location by clicking the empty space on the left side 
of the toolbar and drag it to where you want it located on the screen.  Use the arrow buttons on the toolbar 
to pan or tilt the camera in the direction you want.  

 

 

You can enlarge an area of the video by pressing the 

Zoom

 button on the front panel.  For a few seconds 

after pressing the 

Zoom

 button, a rectangle displays on the screen.  A rectangle shows the area that will be 

enlarged.  You can move the rectangle around using the arrow buttons.  Pressing the 

 (Play/Pause) button 

in the Zoom mode enlarges the area in rectangle.  Exit the Zoom mode by pressing the 

Zoom

 button.  While 

in the Zoom mode, the icon   displays if Zoom is selected in the Display setup screen (OSD tab). 

 

 

You can select the camera you want to display on a Spot Monitor.  Press and hold the 

Spot

 button on the 

front panel for three seconds or longer displays the Sequence Menu. 

 

 

 

You can enter the Active Cameo mode by pressing and holding the 

Cameo

 button for three seconds or 

longer in any multi-view format.  The yellow outline surrounding the video indicates the active cameo, 
and pressing the arrow buttons moves the active cameo. Pressing the 

 (Play/Pause) button exits the Active 

Cameo mode.  Selecting Exit Group Edit in the cameo menu displayed when pressing the 

Cameo

 button 

also exits the Active Cameo mode.  The active cameo mode will remains in effect for 15 seconds if there 
is no further operation. 

 

In active cameo mode, press the button for the camera you want to display in the active cameo.  After setting 
the camera number to active cameo, the DVR moves the active cameo to the next cameo.  When the camera 
number exists on the current screen, the active cameo is changed with the existing camera number.  When 
the camera number does not exist on the current screen, the active cameo is replaced by the camera number.  
You can change the screen layout in this way.  

 

  Zoom In / Out            

 

  Focus Near / Far 

 

  Iris Open / Close        

 

  Set / Load Preset

 

Select the camera to be displayed on the Spot Monitor.  Selecting Sequence from the menu 
displays more than one camera on a Spot Monitor sequentially.  Select Sequence again 
to stop sequencing on the Spot Monitor.  Any cameras that are Off, have lost video or are 
set to Covert (unless the user has authority to view covert cameras) will be excluded from 
the sequence.

  

When the Spot Monitor is in the sequence mode, you can set the camera’s 

display dwell time.  Refer to Chapter 3 – Configuration – Display Setup section for details.