Mitsubishi Electronics DX-TL1600EM ユーザーズマニュアル

••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• Initial settings

ENGLISH

■

Setting this unit to delay the boot up time

Because the unit searches for connected devices when power
is turned on, peripheral devices must be turned on before power
is turned on to the digital recorder. To handle peripherals which
take a long time to start up, the unit can be preset to delay the
timing of its search for these devices.

1. Press the POWER button while pressing the REC button to
turn the power on.

• The <DEVICE CHECK> menu will appear.

<DEVICE CHECK>
SCSI ID0:HDD( 60GB)
ID1:NONE
ID2:NONE
ID3:NONE
ID4:NONE
ID5:NONE
@INITIALIZE ALL HDD

BOOT UP DELAY 00

2. Turn the JOG dial to select BOOT UP DELAY, and turn the
SHUTTLE ring to the right.

• The sub-item of the BOOT UP DELAY will start flashing.

ID5:RDD
INITIALIZE ALL HDD

BOOT UP DELAY 00

3. Turn the JOG dial to set the delay time, and turn the
SHUTTLE ring to the right to enter the selection.

• You can set up to 99 seconds.

ID5:RDD
INITIALIZE ALL HDD

BOOT UP DELAY 10

When BOOT UP DELAY is set and timer recording

is performed, the unit will begin recording later than
the time set as the recording time.

4. Press the POWER button.

• The power of this unit will be turned off.

5. Press the POWER button again.

• This unit will start setting up after the preset delayed time
has passed.

If a different peripheral recording device was con-

nected from the last time the unit was booted up, the
<DEVICE CHECK> menu will appear.