Mitsubishi Electronics XD8600 ユーザーズマニュアル
EN-9
Using the remote control
Using the wired remote control
Attached remote control for this projector can be used as a wired remote control with remote control cable. Wired
remote control is useful for operating in a distance or outside of the operating area.
REMOTE 2 IN
REMOTE 2 OUT
REMOTE 2 IN
• For connection, use the pin-pin cable of ø3.5 stereo type,
which is commercially available. However, some cable may
not work correctly.
• When REMOTE 2 OUT terminal on this projector is
connected to the REMOTE 2 IN terminal on the other
projector, the two projectors can be controlled together by
using the remote control.
• When the remote control is connected with remote control
cable, it does not work as a wireless remote control.
• When using the remote control as wired for a long time
period, remove the batteries from it. (Dispose of the
removed batteries according to the cautions on page 6.)
You can control the projector by the remote
control signals reflected on the screen.
However, the remote control distance may be
restricted by the light reflection loss due to
the screen characteristics.
control signals reflected on the screen.
However, the remote control distance may be
restricted by the light reflection loss due to
the screen characteristics.
Operate the remote control
within a distance of 30 m
(98.4 feet) from the projector,
pointing the light beam at the
remote control photo-sensor
(front or rear) of the projector.
Rear of projector
Front of projector
Vertical directions (ceiling mount)
Reception angle
Vertical directions
• Keep the remote control sensor out of direct sunlight or
fluorescent lamp light.
• Keep the remote control sensor at least 2 m (6 feet)
away from fluorescent lamps. Otherwise, the remote
control may malfunction.
• If there is an inverter-operated fluorescent lamp near
the remote control, the remote control operation may
become unstable.
• When you use the remote control too close to the
remote control sensor, the remote control may not work
correctly.
• When the terminal cover is attached, remote control
may not work properly from behind the projector.
Operational range of the remote control
About 30°
About 30°
About 30°
About 30°
About 20°
About 20°
About 5°
About 20°
About 20°