Multiquip BA ユーザーズマニュアル

Before the trowel can be put into operation there are some
components that must be installed before the trowel can be used.
This section provided general instructions on how to install those
components.  Instruction sheet P/N 20485 provides further details
for the handle assembly.

1.

Install the 

 to the gearbox as shown in (Figure 5).

The mounting hardware should be contained in the shipping
container.

The Quick-Pitch™ handle is spring loaded, personal injury
or damage could result from improper handling or
installation. Be careful when installing this component.

Considerable force may be
required when moving the Quick-
Pitch

™

   

 forward or

backward.

2.

On Quick-Pitch™ models, pivot the 

 back

(full pitch)  (Figure 6). This will relax the spring inside the
handle tube. On either  model, spread the handle bar ends
just enough to engage the teeth on the handle tube. Attach
the hand wheel assembly, position handlebar to desired
location, and tighten hand wheel firmly.

2. Feed the throttle cable through the cable housing.  Make sure

the throttle indicator is on 25.4mm (1 in.).

3. Connect the throttle cable to the engine. (Figure 8),  

and (Figure 9), 

.   There should be a piece of wire

installed on the trowel to show where to route the throttle
cable. When connecting the cable housing, make sure that
no more than 

 of the cable housing protrudes

past the housing clamp on the engine.

CABLE HOUSING

ENGINE

THROTTLE

LEVER

SWIVEL STOP

SCREW

THROTTLE

CABLE END

CABLE

HOUSING

CLAMP

1.

Set the 

 (Figure 7) to the idle position by rotating

the grip toward the operator and away from the engine.