GE 164D2966P238 ユーザーズマニュアル

40

SURFACE UNITS WILL NOT

• You must use pans which are absolutely flat. If light can be seen between 

MAINTAIN A ROLLING

the pan bottom and a straight edge, the elements will not transfer heat properly.

BOIL OR FRYING RATE IS 

• Pan bottoms should closely match the diameter of the surface unit selected.

NOT FAST ENOUGH

FOODS COOK SLOWLY

• Improper cookware being used. Pan bottoms should be flat, fairly heavy-weight 

and the same diameter as the surface unit selected.

SURFACE UNITS DO NOT

• Difficulty may be in the main distribution panel of your house, caused by a 

WORK PROPERLY

blown oven-circuit fuse, a tripped oven-circuit breaker, the main fuse or the 
main circuit breaker, depending on the nature of the power supply. If a circuit 
breaker is involved, reset it. If the control box uses fuses, the oven fuse 
(a cartridge-type) should be changed, BUT ONLY BY SOMEONE FAMILIAR 
WITH ELECTRICAL CIRCUITS. If after performing one of these procedures, 
the fuse blows or circuit breaker trips again, call for service.

NOTE: Apartment tenants or condominium owners should ask their building
management to perform this check before calling for service.

• Cooktop surface unit controls are not properly set, or the wrong control knob

is set for the surface unit you are using.

TINY SCRATCHES

• Incorrect cleaning methods have been used, cookware with rough bottoms has 

(may appear as cracks) OR

been used, or coarse particles (salt or sand) were between the cookware and the

ABRASIONS ON RADIANT

surface of cooktop. Use recommended cleaning procedures, be sure cookware 

COOKTOP GLASS SURFACE

bottoms and cookware are clean before use and use cookware with smooth 
bottoms. Tiny scratches are not removable but will become less visible in time 
as a result of cleaning.

METAL MARKINGS

• Do not slide aluminum cookware across the surface. Use recommended  

(may appear as scratches)

cleaning procedure to remove marks.

• Incorrect cleaning materials have been used, encrusted boilovers or grease spatters

remain on the surface. Use a razor scraper and recommended cleaning procedure.

DARK STREAKS

• Use a razor scraper and recommended cleaning procedure.

OR SPECKS

AREAS OF 

• Marks from aluminum and copper pans as well as mineral deposits from water

DISCOLORATION

or food can be removed with the cleaning cream.

ON COOKTOP

HOT SUGAR MIXTURES/

• See the Glass Cooktop Cleaning section.

PLASTIC MELTED TO
THE SURFACE

FREQUENT CYCLING

• Incorrect cookware used. Use only flat cookware to minimize cycling.

OFF AND ON OF 
SURFACE UNITS