KitchenAid KFIS29PBMS ユーザーズマニュアル

REFRIGERATOR USE

■

Allow 3 hours for the refrigerator to cool down and chill water.

■

Allow 24 hours to produce the first batch of ice. Discard the 
first three batches of ice produced.

■

The dispensing system will not operate when either the 
refrigerator door or freezer drawer is open.

Air in the water dispensing system can cause the water dispenser 
to drip. After connecting the refrigerator to a water source or 
replacing the water filter, flush the water system. 

Flushing the water dispensing system, forces air from the water 
line and filter and prepares the water filter for use. Additional 
flushing may be required in some households.

NOTE: As air is cleared from the system, water may spurt out of 
the dispenser.

1. Using a sturdy container, depress and hold the water 

dispenser paddle for 5 seconds.

2. Release the dispenser paddle for 5 seconds. Repeat steps 1 

and 2 until water begins to flow. 

3. Once water begins to flow, continue depressing and releasing 

the dispenser pad (5 seconds on, 5 seconds off) until a total 
of 3 gal. (12 L) has been dispensed.

Household water pressure may affect the accuracy of the 
Measured Fill feature. So, for optimum performance of your water 
dispenser, you must first calibrate Measured Fill.

IMPORTANT: Flush the water system before calibrating 
Measured Fill. 

1. Place a sturdy measuring cup (1 cup [237 mL] size) on the 

dispenser tray centered in front of the water dispenser 
paddle. 

NOTE: Depending on your model, a measuring cup may be 
provided.

2. Press and hold the OPTIONS and LOCK buttons at the same 

time for 3 seconds. The words “Back” and “1 Cup” will 
appear on the display screen. Also, the Calibrate Measured 
Fill icon will illuminate and remain lit while the Measured Fill 
feature is being calibrated. 

NOTE: You may press ICE MODE “Back” at any time to exit 
calibration mode. The Calibrate Measured Fill icon will turn 
off. 

3. Press and release the water dispenser paddle, as needed, to 

dispense water to the 1 cup fill line. 

NOTE: If overfilling or spilling occurs, discard the water and 
press ICE MODE “Back” to restart the calibration process.

A

B