KitchenAid 2302428 ユーザーズマニュアル

 

Graphics are included later in this section.
NOTE: These instructions are for the Architect

®

 Series doors with 

curved handle only.
1. Using a

 ¹⁄₈" Allen wrench, loosen the two set screws located 

underneath each handle.

2. Pull handle straight out from the door. Make sure you keep 

screws for reattaching handles.

IMPORTANT: 

■

Unplug refrigerator or disconnect power.

■

Remove food and any adjustable door or utility bins from 
doors.

■

If you are only removing and replacing the doors, the 
instructions are the same regardless of door style.

■

If you have a standard or contour door and are also going to 
reverse the door swing, follow the instructions for the 
appropriate door style.

■

All graphics referenced in the following instructions are 
included later in this section after “Final Steps.”

⁵⁄₁₆

TOOLS NEEDED: 

⁵⁄₁₆

 hex-head socket wrench, #2 Phillips 

screwdriver, flat-blade screwdriver, 

⁵⁄₁₆

 open-end wrench, flat 2" 

putty knife.
1. Unplug refrigerator or disconnect power.
2. Open refrigerator door and remove base grille from the bottom 

front of the refrigerator. See Base Grille graphic.

3. Close the refrigerator door and keep both doors closed until 

you are ready to lift them free from the cabinet.
NOTE: Provide additional support for the doors while the 
hinges are being moved. Do not depend on the door magnets 
to hold the doors in place while you are working.

4. Remove the parts for the top hinge as shown in Top Hinge 

graphic. Lift the freezer door free from the cabinet.

5. Remove the parts for the center hinge as shown in the Center 

Hinge graphic. Lift the refrigerator door free from the cabinet.

6. Remove the parts for the bottom hinge as shown in the 

Bottom Hinge graphic.

IMPORTANT: 

■

Architect

®

 Series doors with curved handle are not reversible.

■

If you want to reverse your standard or contour doors so they 
open from the opposite side, follow these steps. If you are not 
reversing the doors, see “Replace Doors and Hinges” later in 
this section.

Graphics are included later in this section.

1. Remove 

⁵⁄₁₆" hex-head hinge screws from handle side and 

move them to opposite side. See Graphic 1-1.

2. Remove cabinet hinge hole plugs from cabinet top and move 

them to opposite side hinge holes as shown. See
Graphic 1-2.

1. Remove freezer handle assembly as shown. Keep all parts 

together. See Graphic 2.

2. Remove door hinge hole plug. Move to opposite side as 

shown. See Graphic 3.

3. Remove door handle sealing screws. Move to opposite side of 

freezer door as shown. See Graphic 4.

4. Remove door stop. Move to opposite side of freezer door as 

shown. See Graphic 5. 

5. Position handle on opposite side of freezer door. Assemble 

handles on door as shown. See Graphic 2.

6. Tighten all screws. Set aside door until hinges and refrigerator 

compartment door are in place.

Door Stop Screw

Door Handle Sealing Screw

Flat-Head Handle Screw

Door Handle Seal Screw Front 

Door Hinge Hole Plug

Cabinet Hinge Hole Plug

Round-Head Handle Screw

Shoulder Handle Screw