KitchenAid KFIS29BBMS ユーザーズマニュアル

FILTERS AND ACCESSORIES

1. Locate the accessory packet in the refrigerator and remove 

the water filter. 

2. Take the water filter out of its packaging and remove the 

cover from the O-rings. Be sure the O-rings are still in place 
after the cover is removed.

3. The water filter compartment is located in the right-hand side 

of the refrigerator ceiling. Push up on the compartment door 
to release the catch, then lower the door. 

4. Align the arrow on the water filter label with the cutout notch 

in the filter housing and insert the filter into the housing.

5. Turn the filter clockwise 90 degrees (

¹⁄₄ turn), until it locks into 

the housing.

NOTE: If the filter is not correctly locked into the housing, the 
water dispenser will not operate. Water will not flow from the 
dispenser.   

6. While the compartment door is still open, lift the filter up into 

the compartment. Then, close the filter compartment door 
completely.

7. Flush the water system. See “Flushing the Water Filter” in the 

“Water and Ice Dispensers” section.

IMPORTANT: If you do not flush the water system, you may 
experience dripping and/or decreased flow from the water 
dispenser.

Press OPTIONS on the control panel to launch the Options menu. 
Press OPTIONS, under Filter Status, again to display the 
percentage of filter life remaining (from 100% to 0%). Press ICE 
MODE to return to the Normal screen. 

The water filter status lights will help you know when to change 
your water filter. 

■

ORDER (yellow) - it is almost time to change the water filter. 
While you are dispensing water, “Order Filter” will blink seven 
times and sound an alert tone three times. 

■

REPLACE (red) - Replace the water filter. While you are 
dispensing water, “Replace Filter” will blink seven times and 
an alert tone will sound three times. 

■

RESET the water filter status tracking feature. After you 
replace the disposable water filter with a new filter, closing 
the filter compartment door will automatically reset the filter 
status tracking feature. See “Using the Controls.”

NOTE: “Replace Filter” will remain illuminated if a filter is not 
installed or is installed incorrectly.

Do not use with water that is microbiologically unsafe or 
of unknown quality without adequate disinfection before 
or after the system. Systems certified for cyst reduction 
may be used on disinfected waters that may contain 
filterable cysts.

B

A