KitchenAid TX802RTDF-CU10-F-2 SERIES ユーザーズマニュアル

■

Remove tape and glue residue from surfaces before turning 
on the wine cellar. Rub a small amount of liquid dish soap over 
the adhesive with your fingers. Wipe with warm water and dry.

■

Do not use sharp instruments, rubbing alcohol, flammable 
fluids, or abrasive cleaners to remove tape or glue. These 
products can damage the surface of your wine cellar. For 
more information, see “Wine Cellar Safety.”

■

Dispose of/recycle all packaging materials.

After you remove all of the packaging materials, clean the inside of 
your wine cellar before using it. See the cleaning instructions in 
“Wine Cellar Care.”

IMPORTANT: 

■

Create custom overlay frame according to the specifications 
in the “Custom Overlay Frame” section.

■

KitchenAid is not responsible for the removal or addition of 
molding or decorative panels that would not allow access to 
the appliance for service.

IMPORTANT: Do not remove the grease from the washer, top 
spacer or top hinge pin. Be sure to set aside the top hinge, top 
spacer and washer for later use.
1. Using a Phillips screwdriver, remove the three screws from the 

top hinge. Remove the top hinge.

2. Remove the three screws from the top spacer. Remove the 

top spacer and washer.

3. Open the door. Lift the front of the door up, pulling straight out 

to remove as shown.

NOTE: If the overlay hooks are not installed, see “Custom Overlay 
Frame” for overlay hook locations.
1. Position the overlay frame 

¹⁄₂" (1.27 cm) higher than the door. 

Be sure to position the overlay hooks to the pilot holes. 

Your wine cellar is heavy. When moving the wine cellar for 
cleaning or service, be sure to cover the floor with 
cardboard or hardboard to avoid floor damage. Always pull 
the wine cellar straight out when moving it. Do not wiggle 
or “walk” the wine cellar when trying to move it, as floor 
damage could occur.