Multiquip HATZ1D81S-325 ユーザーズマニュアル

This section is intended to assist the operator with the 

initial startup of the compactor. It is extremely important 

that this section be read carefully before attempting to use 

the compactor in the field.

1.  Insert the key to the key switch.
2.  Move the throttle lever (Figure 11) to the 

idle position.

3.  Turn the key to the "Run" position (Figure 12). The 

buzzer sounds.

4.  After "HA" is displayed on the hour tachometer, the 

display will change immediately to "cumulative time" 

(Figure 13).

DO NOT attempt to operate the compactor 

until the Safety, General Information and 

Inspection sections of this manual have 

been 

Stop position

Throttle lever

Handle

Idle position

"HA" is displayed at the operation position, then 

immediately it will change to "Cumulative time". 

5.  Turn the key further to the "Start" position to start the 

engine. When the engine starts, let go of the key. When 

the engine revolution increases, the buzzer stops.

6.  When the engine is in operation, the Hour Tachometer 

display will show the "rotation number" (Figure 14).

7.  After the engine has started, warm up the engine at low 

speed for 2 to 3 minutes, especially in cold weather.

Rotation number

Cumulative time

When the engine does not start, do not run the cell 

motor continuously for more than 5 seconds. Move 

the key back to the "Run" position then wait about 10 

seconds to restart.
While the engine is running, never turn the key switch 

to the "Start" position.