Manitowoc Ice GSI 200 プリント

GSI 200 TIMER/BACK COVER REPLACEMENT

Installation Instructions

REPLACING THE TIMER CIRCUIT BOARD REQUIRES REPLACEMENT OF THE BACK PANEL

Timer Housing Back Cover

Timer Circuit Board

All Models

1. Install two (2) fresh AA batteries in timer housing

noting proper polarity (+/-).

Verify timer circuit board is in the correct
position. Snapping the control board under all
four legs will correctly position the control board.
The circuit board is incorrectly positioned if both
lights (red and green) flash at the same time when
the rear cover is installed

3. Verify the small key slots are on the right side

when viewed from the front of the timer housing.
Align sachet holder mounting plate holes with
pins in the timer cover housing and snap into
place.

4. Use four pan-head screws to secure the back

cover/sachet mounting plate to the timer housing.

5. Attach sachet holder to mounting plate. Final

assembly will be with sachet holder opening
facing up.
a. Rotate sachet holder 90

 clockwise.

b. Refer to table to determine if upper or lower

keyhole slots are used. Place left side pin in
the sachet mounting plate keyhole.

c. Rotate sachet holder 90

 counterclockwise and

place right side pin in keyhole slot.

d. Push sachet holder down into keyhole slots to

secure.

Manitowoc Ice, Inc.
2110 South 26th Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA 8014383

Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879 Sheet 1 of 2
Web Site - www.manitowocice.com 03/12/03

RESET BUTTON

FINAL POSITION IS

WITH OPENING

FACING UP

ROTATE 90

 TO

ATTACH LEFT SIDE,

THEN ROTATE TO

FINAL POSITION TO

ATTACH RIGHT SIDE

Attach Sachet

Mounting Plate to Back

Cover Pins

Upper Keyhole Slot

Small Keyhole Slots on
right side when viewed

from front

Lower Keyhole Slot

PLACE TIMER BOARD ON

THE FOUR SUPPORTS

SNAP THE CONTROL BOARD UNDER

ALL FOUR LEGS TO SECURE

POSITIVE

TERMINALS