Honeywell DR4300 ユーザーズマニュアル

The functions in this group are used to specify proper chart function. For a 2-pen recorder the desired input 
channel is displayed on the left side of the operator interface.  

Press FUNC  key to select channel. 

 

Table 4-7 lists all the function prompts in the chart parameters set up group. 

Press SET UP  key until “CHART” appears in the lower display.  

Press FUNC  key to display parameters. 

 

 

—This is the time it will take to drive the 

chart one complete revolution. 

 This prompt only appears for pen 1 

configuration of a two-pen recorder. 

8HR 
12HR 
24HR   [factory setting] 
7DAYS 
– HR 

8 hour revolution 
12 hour revolution 
24 hour revolution 
7 day revolution 
– hour revolution—specify Hours per Revolution selection 
at prompt “HR/REV”. 

1 to 744 Hours 

—Set the desired chart 

speed. Appears only if – HR was selected at prompt 
“CHTSPD”. 

 

LIN   [factory setting] 
NLIN 

—Selection is based on the type of chart. 

 
Linear (even) or 
Non-Linear (i.e., J T/C or RTD) 

 LIN chart type is automatically selected 

when input type is linear (as defined by value of input set 
up parameter “INTYP”).