Sony 8000SF ユーザーズマニュアル

388

Key Setting Operations Using Menus

  

 Chap

Split: You can select a key source signal independently of the key source 

automatically selected in Auto Select mode.

When [Split] was selected in step 5, hold down the [SPLIT] button in the 
key control block, then in the cross-point control block key 1 row, select 
the key source signal. Alternatively, hold down the key delegation button 
in the transition control block and press a cross-point button in the key 1 
row to select the key source signal.

• In the above-stated key 1 row operation, you can only select a key signal 

assigned to a cross-point button. For the method of selecting a video 
signal, see “To select a video signal assigned to a cross-point button” 
below.
On the MVS-8000, the video signal selection operation is not supported.

• When [Split] is selected, the key memory function (see page 56) is 

disabled.

To select a video signal assigned to a cross-point button
By selecting the key source bus with an auxiliary bus control block AUX 
delegation button, and pressing the cross-point button, it is possible to select 
the video signal assigned to the cross-point button.
(If you press the cross-point button with holding down [KEY], the key signal 
assigned to the cross-point button.)

In the above operation, the following settings must have been made.
• Assigning the key source bus to an AUX delegation button

• Setting the [KEY] button operating mode

This operation is not supported on the MVS-8000.

When [Matte] is selected for key fill, you can combine color 1 and color 2. For 
the combination, you can use not only a key wipe generator pattern, but also 
the dedicated pattern for key edge color mix.