Cisco Systems 3 ユーザーズマニュアル
C H A P T E R
3-1
Catalyst 2948G-L3 and Catalyst 4908G-L3 Software Feature and Configuration Guide
78-10408-01, Cisco IOS Release 12.0(7)W5(15d)
3
Initial Switch Router Configurations
This chapter describes how to initially configure the Layer 3 switch routers.
•
•
•
•
•
•
•
Note
You are at Step 2 in the suggested process for configuring your Layer 3 switch router
(see Table 2-1 on page 2-1). You should have already set up the hardware before
proceeding with the initial switch router configurations.
(see Table 2-1 on page 2-1). You should have already set up the hardware before
proceeding with the initial switch router configurations.
Starting Up the Layer 3 Switch Router
The following is a review of tasks you should have completed during hardware installation, including
starting up the switch router. These tasks must be completed before proceeding with configuring your
switch router.
starting up the switch router. These tasks must be completed before proceeding with configuring your
switch router.
Step 1
Check that the switch router is set for the correct AC (or DC) power voltages.
Refer to the Catalyst 2948G-L3 Hardware Installation Guide or the Catalyst 4908G-L3 Hardware
Installation Guide for correct power voltages.
Installation Guide for correct power voltages.
Step 2
Connect the cables to the switch router.
Step 3
Connect the console terminal to the switch router.