Cisco Systems 3030 ユーザーズマニュアル

This guide provides instructions on how to install your Cisco Catalyst Blade 
Switch 3030—hereafter referred to as the switch module—in the Dell Modular 
Server Chassis and to set up and configure your switch module. The Dell Modular 
Server Chassis—hereafter referred to as the server chassis—is a system that 
supports up to ten server modules and up to four Ethernet switch modules. The 
switch module is installed in one of the chassis I/O module bays on the rear panel 
of the server chassis.

Also covered in this guide are switch management options and troubleshooting 
help for the switch module.

For details on the number, types, and the location of the module bays and for 
additional information on the entire modular server system, see the Dell 
PowerEdge 1855 Systems User's Guide and the Dell PowerEdge 1855 Systems 
Installation and Troubleshooting Guide at 

For additional installation and configuration information about the switch 
module, see the Cisco Catalyst Blade Switch 3030 documentation on Cisco.com. 
For system requirements, important notes, limitations, open and resolved caveats, 
and last-minute documentation updates about the switch module, see the release 
notes, also on Cisco.com.

When using the online publications, refer to the documents that match the Cisco 
IOS software version that is running on the switch. You can order printed copies 
of the manuals from the Cisco.com sites and from the telephone numbers listed in 
the