Mitsubishi Electronics DATA PROJECTOR ユーザーズマニュアル

Cr

Cb

Y

Pr

Pb

Y

COMPONENT

COMPONENT

• The projector has been set to “Auto” at the factory; however, if it does not project, please change the input setting to “Compo-

nent” using the menu sequence of [Setup] 

→ [Input Format] → [RGB].

See “Input Format” on Page E-53.

• When projecting the YCbCr signal or YPbPr signal, if the color of the overall image strongly leans toward being greenish or

another color, change the setting under the menu of [Color] 

→ [Color Space].

See “Color Space” on Page E-47.

Green

Blue

Red

Green

Blue

Red

Projecting component signals
Please note that when inputting 480i or 576i signals using a separately sold component cable and viewing video images, depending on the
connected device and the video source being projected, the picture may be disturbed or may not be projected properly.
In such cases, it is possible to achieve a picture with no disturbance that is projected properly by either switching to 480p signals or
connecting using an S-Video cable instead.

Note:
* When the input format has been switched, you may be required to reconnect the input signal.
* In some rare cases, the picture may not be displayed, depending on the connected device.