Mitsumi electronic HC3800 ユーザーズマニュアル
EN-
Viewing computer images
A. Connecting the projector to a computer
Preparation:
Make sure that the power of the projector and that of the computer are turned off.
When connecting the projector to a desktop computer, disconnect the RGB cables that are connected to the
monitor.
When connecting the projector to a desktop computer, disconnect the RGB cables that are connected to the
monitor.
Connect one end of the supplied RGB cable to the
COMPUTER IN/COMPONENT VIDEO IN terminal of the
projector.
Connect the other end of the RGB cable to the monitor port
of the computer.
Additional devices, such as a conversion connector and an
analog RGB output adapter, are required depending on the
type of the computer to be connected.
When viewing images supplied from an analog-connected
computer, press the COMPUTER button on the remote
control.
Turn on the power of the projector before that of the
computer.
Additional devices, such as a conversion connector and an
analog RGB output adapter, are required depending on the
type of the computer to be connected.
Use of a long cable may decrease the quality of projected
images.
Also read the instruction manual of the equipment to be
connected.
Images may not be projected correctly, depending on the
type of the computer connected.
Contact your dealer for details of connection.
COMPUTER IN/COMPONENT VIDEO IN terminal of the
projector.
Connect the other end of the RGB cable to the monitor port
of the computer.
Additional devices, such as a conversion connector and an
analog RGB output adapter, are required depending on the
type of the computer to be connected.
When viewing images supplied from an analog-connected
computer, press the COMPUTER button on the remote
control.
Turn on the power of the projector before that of the
computer.
Additional devices, such as a conversion connector and an
analog RGB output adapter, are required depending on the
type of the computer to be connected.
Use of a long cable may decrease the quality of projected
images.
Also read the instruction manual of the equipment to be
connected.
Images may not be projected correctly, depending on the
type of the computer connected.
Contact your dealer for details of connection.
About DDC
The COMPUTER IN/COMPONENT VIDEO IN terminal of this projector complies with the DDC1/B standard and the
HDMI IN terminal comply with the DDCB standard. When a computer supporting this standard is connected to this
terminal, the computer will automatically load the information from this projector and prepare for output of appropriate
images.
HDMI IN terminal comply with the DDCB standard. When a computer supporting this standard is connected to this
terminal, the computer will automatically load the information from this projector and prepare for output of appropriate
images.
After connecting a computer supporting this standard to this terminal, plug the power cord of the projector in the
wall outlet first, and then boot up the computer.
wall outlet first, and then boot up the computer.
B. Plugging the power cord
Plug the power cord in the same way as described in “Viewing video images.” (See page 17.)
•
•
•
1.
.
•
•
•
•
•
•
•
•
•
2
1
To monitor port
COMPUTER IN/
COMPONENT VIDEO IN
RGB cable
2
1
To monitor port
COMPUTER IN/
COMPONENT VIDEO IN
RGB cable