MotoSAT Nomad 2 ユーザーズマニュアル

 

13

 

The Control Cable, 9 conductors, colored coded, 22Awg stranded that connects to the 
mount with a twist lock connector is configured in the following manner: 
 

Black   

1 

Motor, Azimuth Positive 

 

*Brown 2 

Motor, Azimuth/Skew 
Negative 

 

*Red 3 

Motor, Elevation/Skew 
Positive 

 

Orange 4 

Motor, Elevation 
Negative 

 

Yellow 5 

Sensor, Count Azimuth 

3.408 

Green 6 

Sensor, Ground 
Azimuth/Elevation 

 

Blue 7 

Sensor Count Elevation 

5.034 

White 8 

Power, Mount LED 

 

**Purple 9 

Sensor, 

Count 

Skew 

8.500 

* The Brown and Red wire perform a dual function when used on a Skewable 
(MD500/MHDTV) mount.  They control the Skew motors when directed by the 
Nomad 2 Controller.  Applying 12 volt power directly to these wires will skew the 
dish. 
**The Purple cable is for use on skewable dishes but it WILL NOT effect the 
operations of a non-skewable dish when it is connected (or not connected). 
 

 
The Mount is coil wrapped inside with the following cables and wire: 

2 ea     RG179 Teflon coated coax cables (can do four (4) if required) 
1 ea     Control Cable, 9 conductor cable, colored coded, 22Awg stranded.  This cable 

is molded with a twist lock connector on one end and manually terminated 
at the other with a 9 pin connector. 

  
2 or 4 ea      RG179 coax cables terminate at the LNB to provide availability of 

cabling for multiple receivers. 

1 ea     Black and White 22Awg stranded wires carry the positive (white) voltage and 

ground (black) to the LED which is used to illuminate the dish face. 

 

For any questions or comments please contact our 

Technical Support Department at 1-800-247-7486.