GE 25982xx3 ユーザーズマニュアル

41

UNAVAILABLE 

Indicates the handset is out of range. Or an additional handset 

is in use. Or there has been a base power failure, in which case 

you must place all handsets on the main base cradle for 0 

seconds to re-establish link with the base.

UNKNOWN NAME/  The incoming call is from an area not serviced by Caller ID or

the information was not sent.

WAITING HANDSET  Prompt telling you to enter registration mode of handset.

REGISTRATION 

A long warbling tone (with ringer on) 

 

Signals an incoming call

Three short beeps 

 

Page signal

One short beep (every 7 seconds) 

 

Low battery warning

No dial tone

• Check and repeat installation steps:
  Ensure the base power cord is connected to a working outlet .
  Ensure the telephone line cord is connected to the base and the wall jack.
• Connect another phone to the same jack; if there is still no dial tone, the problem 

might be your wiring or local service.

• The cordless handset may be out of range of the base. Move closer to the base.
• Ensure the battery is properly charged (16 hours).
• Ensure the battery pack installed correctly. 
• Did the handset beep when you pressed the TALK/CALL BACK or SPEAKER 

button? The battery may need to be charged.

• Place handset in charge cradle for at least 0 seconds.

Dial tone is OK, but can’t dial out 

• Make sure the TONE/PULSE setting on the base is set to the type of phone 

service you are subscribed to.