ユーザーズマニュアル目次Table of Contents6Safety2Section A - Installation7Section B - Operation15Section C - Accessories27Section D - Maintenance36Section E - Theory of Operation47Section F - Troubleshooting & Repair54Symptoms57Major physical or electrical damage is evident.57No welding output in neither Stick or CV modes. The engine operates normally. The auxiliary output is normal.57No welding output in neither Stick or CV modes. Also no auxiliary power. The engine operates normally.58No auxiliary power at the receptacles. The welding output is normal and the engine operates normally.58The machine has welding output but no control of output. The auxiliary power is normal.59The machine has low welding output and low auxiliary output.59The machine control is still active when the remote control unit is attached.60The machine seems locked into the CC mode of operation (Stick mode).60The wire feeder does not work when connected to the welder amphenol.61The battery does not stay charged.61The engine will not crank when the start button is pushed.62The engine cranks but will not start.62The engine shuts down shortly after starting.63The engine will not idle down to low speed. The machine has normal weld output and auxiliary power.63The engine will not go to high idle when using the auxiliary power. Auxiliary power is normal when the IDLER switch is in the64The engine will not go to high idle when attempting to weld or when the auxiliary power is loaded. Welding output and ...64The machine goes to low idle but does not stay at low idle.64The welding arc is "cold." The engine runs normally. The auxiliary power is normal.65Section G - Electrical Diagrams137SVM Error Reporting Form156サイズ: 4.78MBページ数: 156Language: Englishマニュアルを開く