ユーザーガイド目次Introduction8Projector Features8Package Contents9Projector with Lens Cap9AC Power Cord9VGA Cable (D-SUB to D-SUB)9Projector Overview10Using the Product12Control Panel12Connection Ports13Remote Control14Replacing the Battery151. Push the catch to the left and remove the battery holder.152. Remove the old Lithium coin cell and install new one (CR2025). Ensure that the side with the mark “+” is up.153. Push the battery holder back into the remote control until you feel a click.15Remote Control Operation16Installation17Connecting the Projector17Powering On/Off the Projector18Powering On the Projector:181. Remove the projector lens cap.182. Complete the AC power cord and peripheral signal cable(s) connections.183. Press button on the control panel or the POWER button on the remote control to turn on the projector. The projector takes a minute or so to warm up.184. Turn on your source (computer, notebook, DVD, etc.). The projector automatically detects your source.18Powering Off the Projector:181. Press button on the control panel or the POWER button on the remote control to turn off the projector lamp. You will see a message "Power off? Press Power again" appear on the screen.182. Press button on the control panel or the POWER button on the remote control again to confirm.183. Disconnect the AC power cord from the electrical outlet and the projector.184. Do not turn on the projector right after power off.185. This projector supports Off-To-Go function. User can safely cut off the power source immediately without causing harm to the projector lamp.18Adjusting the Projector19Adjusting the Projector Height19Adjusting the Projector Zoom and Focus191. Focus the image by rotating the focus ring. A still image is recommended for focusing.192. Adjust the image by sliding the zoom ring.19Adjusting Projection Image Size20Menu Operation211. Press the MENU button to open the OSD menu.222. When OSD is displayed, use p / q to select any feature in the main menu.223. After selecting the desired main menu feature, press u to enter sub-menu for feature setting.224. Adjust the settings with t / u.225. Press the MENU button, the screen will return to the main menu.226. To exit OSD, Press the MENU button again. The OSD menu will close and the projector will automatically save the new settings.22Maintenance25Cleaning the Lens25Cleaning the Projector Housing25Replacing the Lamp261. Turn off the projector.272. Unplug the power cord.273. Loosen the screw in the lamp cover and remove the cover.274. Loosen the two screws from the lamp module.275. Pull up the handle, and then pull out the lamp unit by the handle.276. Insert a new lamp module into the projector and tighten the screws.277. Replace the lamp cover and tighten the screw.278. Turn on the projector. If the lamp does not turn on after the warm-up period, try reinstalling the lamp.279. Reset the lamp hour. Refer to the Setting (Computer / Video Mode) menu.27Specifications28Appendix29LED Indicator Messages29Compatibility Modes30Computer:30Video:30Troubleshooting31Start-up problems31Image problems31RS-232 Command and Configuration32IR Control Code33サイズ: 1.92MBページ数: 39Language: Englishマニュアルを開く