3M 2250M-iD 사용자 설명서

78-8130-6150-0 Rev G 

27

In two-person active induction mode sweeps, one person holds the transmitter and 

the other holds the receiver while walking together in a sweep pattern detecting long 

conductors in the ground when crossed by transmitter and receiver positions and 

orientation, as shown below:

Transmitter Set-up
•  Remove anything plugged into the Output Jack [T-6] (this will place unit in Induction 

Mode), select high frequency (200 kHz), or medium frequency (33 kHz or 82 kHz), 

and highest output power level.

•  Hold the transmitter with the lid facing up and align it with the Induction Direction 

arrow label, as shown on the transmitter, with the receiver

Receiver Set-up
•  Set the receiver to the same frequency as the transmitter.
•  Select the Induction Peak (Ind Pk) mode, and press the Gain Adjust [4] (+ or -) key 

until the bar graph is just visible.

Sweeping
•  Sweeping can be done at close distances between the transmitter and receiver.
•  For best results, the receiver should be at least 25 feet (7.6 m) away from the 

transmitter to begin tracing the target path and have the gain set between 78-84% 

when starting the sweep. Attempting to trace the target close to the transmitter may 

lead to false indications due to the receiver detecting the large magnetic field radiating 

from the transmitter.

•  Induction Peak (Ind Pk) mode cancels the air signal coming directly from the 

transmitter induction antenna to the receiver. Increasing the sweep distance between 

the transmitter and receiver reduces the direct air signal and allows for sensing 

deeper conductors and sections of metal pipes. Use Induction Peak (Ind Pk) mode 

when sweeping distance between the transmitter and receiver is 25–60 feet (7.6–20 

m). Beyond 60 feet (20 m) you can also use the Special (single) Peak (Spl Pk) or 

Directional Peak (Dir Pk) modes.

•  Special (single) Peak (Spl Pk) can be used for maximum detection depth and range 

(needed for deep conductors and metal pipes), but would require increased sweep 

distance separation between the transmitter and receiver.