Frigidaire 137181700A 사용자 설명서
![Frigidaire](https://files.manualsbrain.com/attachments/cb0b9e68342faca4070c18fc6a4702d9b3fb17f3/common/fit/150/50/a537c1ed13cba0d844f138bfae5daaa9ca916c30c585d85d30c648297788/brand_logo.jpeg)
14
SOLUTIONS TO COMMON PROBLEMS
Common Drying Problems
Many drying problems involve poor cleaning results, poor soil and stain removal, residues of lint and scum, and fabric
damage. For satisfactory drying results, follow these suggestions provided by The Soap and Detergent Association.
damage. For satisfactory drying results, follow these suggestions provided by The Soap and Detergent Association.
PROBLEM
POSSIBLE CAUSES
SOLUTIONS
PREVENTIVE MEASURES
Greasy, oily
stains
stains
Fabric softener sheet.
•
Rub fabric softener stains with
•
bar soap. Rinse and rewash.
Add a few bath towels to small loads
•
for proper tumbling.
Some “silk-like” fabrics should be air
Some “silk-like” fabrics should be air
•
dried.
Use proper drying temperature.
Use proper drying temperature.
•
Place fabric softener sheet on top of
•
load before starting the dryer.
Lint
Overloading.
•
Overdrying causes static
•
electricity.
Lint screen not clean when
Lint screen not clean when
•
cycle began.
Lint is attached to “pills.”
Lint is attached to “pills.”
•
Reduce load size and rewash
•
using liquid fabric softener in the
final rinse.
Or, add a fabric softener sheet
final rinse.
Or, add a fabric softener sheet
•
and tumble without heat.
Use lint brush or roller to remove
Use lint brush or roller to remove
•
lint.
Do not overload dryer.
•
Use fabric softener in washer or dryer
•
to reduce static electricity.
Remove items when they are slightly
Remove items when they are slightly
•
damp to avoid overdrying.
Check that lint filter is clean and in
Check that lint filter is clean and in
•
place.
Pilling
(Fibers break
off, ball up and
cling to fabric.)
(Fibers break
off, ball up and
cling to fabric.)
Overdrying.
•
Use a lint brush or shaver to
•
remove pills.
Use fabric softener to lubricate fibers.
•
When ironing, use spray starch or
•
fabric finish on collars and cuffs.
Turn items inside out to reduce abra-
Turn items inside out to reduce abra-
•
sion.
Shrinking
Temperature too high.
•
Overdrying.
•
Irreversible condition.
•
Follow fabric care label directions.
•
If shrinking is a concern, check load
•
often.
Remove items while slightly damp and
Remove items while slightly damp and
•
hang or lay flat to complete drying.
Block knits into shape.
Block knits into shape.
•
Wrinkling
Overloading.
•
Leaving items in dryer after
•
cycle ends.
Reduce load size and tumble at
•
medium or low heat for 5-10
minutes.
Remove items immediately. Hang
minutes.
Remove items immediately. Hang
•
or fold.
Do not overload dryer.
•
Remove items as soon as cycle ends.
•