Sony UPX-C200 사용자 설명서

Troubleshooting

64

If you run into any problem when using your UPX-
C200, use the following table as a guide to troubleshoot 
the problem. If the problem persists, contact your Sony 
dealer or local authorized Sony service facility. 

Power is not turned off 
even if the POWER 
switch is set to OFF.

• The camera requires a long period 

of time for internal processing.
tWait a while, and if the power is 

not turned off, disconnect the AC 
power adaptor from the camera 
or open the battery compartment 
lid.

The POWER switch of 
the camera is set to ON, 
but the camera and 
printer are not 
connected.

tSet the Bluetooth function to OFF 

then ON again.

tRemove the printer, and add it 

again. (Refer to the Operating 
Instructions (Advanced 
Operations).)

A picture cannot be 
taken when you press 
the release button.

• The PLAY/CAMERA switch is not 

set to CAMERA.
tSet the switch to CAMERA.

• The camera is taking a picture or 

charging the flash (the standby lamp 
is flashing in red).
tWait until the standby lamp 

lights or flashes in green.

• The memory is full (the standby 

lamp is lit in red).
tCheck the displayed remaining 

number of pictures that can be 
taken. If zero, erase any picture 
that is not necessary.

tSet AUTO ERASE to ON. 

(Refer to the Operating 
Instructions (Advanced 
Operations).)

The flash does not light. • Flash Mode is not set appropriately.

tSet FLASH MODE in menu to 

A ,   or M .

• The cord of the external flash is not 

connected to the camera.
tConnect the cord of the external 

flash to the FLASH jack of the 
camera.

• The batteries are discharged.

tCharge the batteries or replace 

them with a new one.

• The flash may be out of life. 

tContact your Sony service 

facility or your Sony dealer.

No playback picture 
appears.

• The MONITOR (PAL) switch of the 

camera is set to VIDEO OUT when 
a video cable is connected and 
VIDEO OUT of the menu is set to 
PAL.
tSet the switch to LCD.
tDisconnect the video cable.

If played back in cold 
weather, the picture 
may seem to present 
curved sides.
The image presents 
some red, blue and 
green dots, or there are 
black spots visible.

Condition due to the liquid crystals.
tNormal condition

Animation of paper

• The printer is printing a picture.

tWait until printing is finished. 

Then try again.

Data transmission ends, 
but the display freezes 
up.

• The printer is supplying print paper.

tWait until paper supply finishes 

and printing begins. Then the 
displayed picture changes.