Elmo PTC-200C 사용자 설명서

- 18 -

5. THE ID NUMBER SETTING

When multiple Cameras are laid out adjacently and operated via the wireless remote

controller, the Cameras receiving the infrared rays operate in unison in the same way. When

each Camera is allocated with a different ID No., the Camera can be controlled independently

when its ID No. is specified via the wireless remote controller. The ID Nos. can be allocated

for up to 6 Cameras.

(1) Setting an ID No.

• Turn ON only the camera to be set with an ID

No. Leave other adjacent Cameras in the OFF

position. (Unplug their AC adapters from the

Cameras or wall socket).

• Set the remote ID No. to the Camera. (See "6.

OSD (On-Screen Display)" on P. 19.) After

setting, close the Menu screen by pressing

MENU button. Then, repeat the ID No. setting

for all other Cameras in the same way.

(2) Operating the Cameras selectively

• Press

ID button, and the LED's of all adjacent Cameras will start blinking (at

intervals of 0.2 sec). (To cancel this, press

ID button again.) Then, press

through 6 buttons, and the LED's will go out, and selective operation by specifying

the ID No. will be ready. Now, only the selected Camera can be operated via the

wireless remote controller.

(3) Canceling the specific ID of the Cameras

• Hold down

ID button for over 2 sec, and the blinking LED on the Camera will

light up. Then, unhand

ID button. Now, the selective operation has been

cancelled, and all adjacent Cameras start operation via the wireless remote controller.

• Alternatively, the selective operation by specifying the ID No. can also be cancelled

by unplugging the DC jack from the Camera and turning ON the Camera power again.