Enerco TSVFR30LPT 사용자 설명서

Installation Instructions and Owner’s Manual

Unvented LP-Gas Vent Free Room Heaters

If any original wiring as supplied with the heater must 

be replaced, it must be replaced with type AWG 105

o

C 

wire or its equivalent except as indicated.

WARNING: Electrical Grounding Instructions: This 

heater is equipped with a three-prong (grounding) 

plug for your protection against shock hazard and 

should be plugged into a properly grounded three-

prong receptacle. 

WARNING: If you do not follow these instructions 

exactly, a fire or explosion may result causing prop-

erty damage, personal injury or loss of life. 
A.  This appliance has a pilot which must be lighted 

by pushing the ignitor button. When lighting the 

pilot, follow these instructions exactly.

B.  BEFORE LIGHTING smell all around the appli-

ance area for gas. Be sure to smell next to the 

floor because some gas is heavier than air and 

will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•

Do not try to light any appliance.

•

Do not touch any electrical switch; do not use 

any phone in your building.

•

Immediately call your gas supplier from a 

neighbor’s phone. Follow the gas supplier’s 

instructions.

•

If you can not reach your gas supplier, call the 

fire department.

C.  Use only your hand to push in or turn the gas 

control knob. Never use tools. If knob will not 

4.  Correct all leaks at once.
5.  Depressurize and relieve pressure from supply 

piping system.

1.  Make sure that the heater supply piping sys-

tem is connected and has been leak tested as 

described above.

2.  Make sure control knob of heater is in OFF 

position.

3.  Open equipment shutoff valve (see figure 13). 
4.  Open main gas valve on or near gas meter.
5.  Check all joints from equipment shutoff valve 

to control valve (see figure 14). Apply mixture 

of liquid soap and water to gas joints. Bubbles 

forming show a leak.

6.  Correct all leaks at once.
7.  Light heater (see Operating Your Heater, pages 

10 and 11. Check the rest of the internal joints 

for leaks. 

8.  Turn off heater (see To Turn OFF Gas to Appli-

ance, page 11.

9.  Replace lower front panel.