Monte Carlo Fan Company 5MAR52 사용자 설명서

Carefully lift fan assembly onto mounting

bracket. Rotate fan so that the notch on the

ball engages the ridge in the mounting bracket.

This will allow hands-free wiring. 

Install 3 allen screws, washers, and nuts per

blade and tighten securely with allen wrench.

Repeat for all 5  blades. Curve of blade goes

down which is labeled on blades.

Check the motor for plastic shipping stabilizer

tabs, and remove them if they are present.

Attach blade assembly to motor using the motor

screws and washers provided. Tighten screws

securely. Next attach light kit or blanking plate

to the fan.

Make wire connections to power source using

wire nuts provided.  Make sure that no filiments

are outside of the wirenut. After making the

wire connections, the wires should be spread

apart with the grounded conductor and the

equipment-grounding conductor on one side of

the outlet box and ungrounded conductor on

the other side of the outlet box.

white

Red

Make wiring connections as indicated above.

White from fan to white from remote marked

N.  Blue from fan to blue from remote

marked down light. Black from fan to Red

from remote marked L.  White from house to

white from remote marked AC N . Black from

house to Black from remote marked AC  L.

Connect all green ground wires to Ground

wire from House.

blue

Green

white
black

House

Fan

Install remote receiver by sliding into opening in

the Mounting bracket.  Make sure that the dip

switches on the Transmitter and the Receiver

are set to the same position.  See Fig 25 for

remote operation

Plug white wire from fan to white wire  from

light kit. Then plug black from fan to black from

light kit.

Loosen the 2 screws with key slots and remove

the screw without key slot.  Take plate and

place over the 2 screws with key slots  and

twist to hold in place. Tighten the 3 screws

securely holding the plate for the switch hous-

ing.

Raise the canopy up and align the two holes in

the canopy with the two holes in the hanger

bracket. Secure with two  screws provided.

Set dip switches on the Remote Transmitter and Remote

Receiver to the same settings.  This must be done so the

units will communcate properly.  If you have other fans you

can set to control from one transmitter by setting both

receivers the same as the transmitter.  If you have more

than one fan with remote.  You can set the dip switches to

different positiosns to have seperate control.

Remote Transmitter Dip swtiches

Remote Receiver Dip switches

Install the 2 50 watt halogen bulbs. Do not

touch bulb surface as oily residue from skin can

cause the bulb to explode.

For Canadian installation and for USA fan and

light kit combinations over 35 lbs, in both flush

and downrod mode the safety cable must be

installed into the house structure beams using

the 3” lag screws,washers, and lock washers.

provided.  Make sure that when the safety cable

is fully extended the leadwires are longer than

the cable and no stress is placed on the lead-

wires.

Safety cable installation

safety

cable

3” lag

screw

lock

washer

washer