Monte Carlo Fan Company 5LCR52 사용자 설명서

Tighten 2 downrod set screws.

install cotter pin into cross pin.

Install downrod into yoke.

Thread black, white wire, and safety cable

through downrod.

Align hole in downrod with hole in yoke and

install cross pin.

Raise fan with downrod assembled to the ceil-

ing bracket and hang fan assembly.  Be sure to

rotate the downrod ball so that the notch in the

bracket engages the slot in the ball.

For Canadian installation in both flush and

downrod mode the safety cable must be

installed into the house structure beams using

the 3” lag screws provided.  Make sure that

when the safety cable is fully extended the

leadwires are longer than the cable and no

stress is placed on the leadwires.

Make wire connections to power source using

wire nuts provided.  Make sure that no filiments

are outside of the wirenut. After making the

wire connections, the wires should be spread

apart with the grounded conductor and the

equipment-grounding conductor on one side of

the outlet box and ungrounded conductor on

the other side of the outlet box.

Attach blade brackets to blades using the blade

bracket screws and washers provided.

Check the motor for plastic shipping stabilizer

tabs, and remove them if they are present. The

screws, washers and motor pads are pre-

installed to the blade holders. Attach blade

assembly to motor and tighten screws securely.

Make wire connections as per above diagram.

Connect the white wire from the fan to the

White or Neutral wire from the power source.

Connect the black wire from the fan to the

Black or hot wire from the power source.

Connect all Green / Yellow wires from the fan,

Downrod and mounting bracket to the Ground

wire from the house.  

House

Fan

Black

White

Green

Black

White

Green(downrod)
Green(Bracket)

Before attaching blades; remove the switch housing.