Hearth & Home Technologies 3100-I 사용자 설명서

Page 12

     September 1, 2008 

R 

 250-6381D

View of "L" Bracket 

installed

Kit Includes:  (2) Side Panels, left & right; (1) Panel Top & Fastener package; (2) Side Trim, left & right; (1) Trim Top & 

Fastener package.

Tools Needed:  Powered Phillips head screw driver. 

1.  Install the 2 side panels on the insert first, using the cage nuts already attached to the stove, pushing panels away from the 

insert to the maximum distance of the slot.  

See Figure 12A.  (Note: The sides are interchangeable).

.  Put on the top panel and push straight back.  Attach the top panel to the sides using the screws and the panel brackets found in 

the fasteners package.  Now move the side panels inwards (toward insert) into position and tighten screws.

1.  Place protective covering on surface to be used to assemble the trim pieces.  Lay the trim face down.
2.  Attach the 2 side trim pieces to the top trim at each corner using the “L” bracket included in fasteners package.  Slide assembled 

trim over panel set.  

See Figure 12B.

Adjust position by sliding 

left or right after top is in 

place.

Install sides and push out to 

maximum distance of slot.

Panel brackets

831-0862  

Large, Gold  50-1/2” x 34-1/2”

1.  Install washer on door handle shaft.

.  Slide door handle through door.

3.  Install second washer(s) as shown.

4.  Install key in groove.

5.  Align groove in latch cam with key; slide 

latch cam over shaft.

6.  Install locknut.

  Caution!  Do not overtighten locknut.  

7.  Install spring handle turning counter-

clockwise to desired location on handle.

Locknut

Door Cross Section 

(example)

Latch Cam

Spacing 

Washers

Square Key

Door Handle

Spring 

Handle

SP-31S-NL   Std, Nickel 

44-5/8” x 30-1/2”

SP-31L-NL 

Large, Nickel  50-1/2” x

 34-1/2”