Lg Electronics M8004R 사용자 설명서

1. Remove the cabinet. (Refer to section 2)
2. Remove the nut that fastens the terminal cover.
3. Remove the terminal cover. (See Figure 19)
4. Remove all the leads from the overload protec-

tor.

5. Remove the overload protector.
6. Re-install the components by referring to the

removal procedure, above. 

1. Remove the cabinet. (Refer to section 2)
2. Discharge the refrigerant system using a

Freon

TM

Recovery System.

If there is no valve to attach the recovery sys-

tem, install one (such as a WATCO A-1) before

venting the Freon

TM

. Leave the valve in place

after 

servicing the system.

3. Remove the overload protector. (Refer to sec-

tion 7)

4. After purging the unit completely, unbraze the

suction and discharge tubes at the compressor

connections.

5. Remove the 3 nuts and the 3 washers which 

fasten the compressor.

6. Remove the compressor. (See Figure 20)
7. Re-install the components by referring to the

removal procedure, above.

1. Remove the control box. (Refer to section 3)
2. Open the top cover from the control box.

(See Figure 21)

3. Pull out the capacitor from the control box.
4. Disconnect all the leads of capacitor terminals.
5. Re-install the components by referring to the

removal procedure, above.