Samsung HT-DB660 사용자 설명서

58

57

• 

By setting up the RRSS function just once, the speaker distance, channel level, and rear sound
reflection effect are automatically set and create an optimal listening environment. 

• 

This function works only in DVD/CD mode.

Connect the RRSS
Microphone to the
RRSS input jack.

Place the RRSS
Microphone at the
listening position.

Press the RRSS
button.

When "

REMOVE MIC"

appears on the display,
disconnect the RRSS
Microphone.

• 

The RRSS button works as the RRSS setup function shown above if the RRSS Microphone is connected, and works as the rear sound
reflection effect function if the microphone is removed.

• 

If you are installing the system for the first time or if you have initialized the system, "NO MEASURED DATA" will appear on the display
when you press the RRSS button without connecting the RRSS Microphone.

• 

During the RRSS setup, the output volume of the tone is fixed and you cannot use the volume control buttons to adjust the output level.

• 

If you remove the RRSS Microphone during the RRSS setup, the setup will be cancelled.

• 

Place the front and left speakers (L/R) toward the side walls so that the rear speaker sound is reflected against the walls.

•

If the system is installed at a location where sound cannot
be reflected (e.g., an open space without walls), the speaker
distance, channel level, and rear sound reflection effect may
be set incorrectly during the RRSS setup.

*

The following images are for illustrative
purposes only and may differ from the
actual product.

L: Front Speaker (L)

R: Front Speaker (R)

C: Center Speaker 

SW: Subwoofer

LS: Rear Speaker (L)

RS: Rear Speaker (R)

Briefly press the RRSS button.

(If you have set the RRSS for the first time according to

Steps 1 to 3 on the previous page)

•

Your selection will toggle between "

ON" and "REAR REFLECTING OFF" on the display.

•

Select "

REAR REFLELTING ON" to listen using the

RRSS setting and select "

REAR REFLECTING OFF" to

listen to the disc currently being played in its original
setting.

• 

A speaker tone will be heard once
from each speaker in the order of 
L 

➝ C ➝ R ➝ RS ➝ LS ➝ SW, and

then the newly set error tone will be
heard again from L 

➝ R.

• 

An optimal listening environment will
be set up automatically.

• 

It takes about 3 to 4 minutes to
complete the RRSS setup.

Tone Output

A piano sound will be heard and the

setup will be completed.

When you turn on the power, a sound logo will be heard,
indicating that the disc reading is completed and the player is
in its optimal condition to play the disc.

1. Press and hold the RRSS button.

•

"

S.LOGO ON" or "S.LOGO OFF" appears on the

display.

2. Briefly press the RRSS button.

•

Each time you press the button, your selection toggles
between "

S.LOGO ON" and "S.LOGO OFF".

•

Select "

S.LOGO ON" to enable the sound logo and

select "

S.LOGO OFF" to disable the sound logo.

1. Press and hold the RRSS button twice.

•

"

CHECK" appears on the display.

2. Next,briefly press the RRSS button.

•

The speaker distance and level value for each channel
will be displayed.

Press the RRSS button.

•

The tone output stops, "

CANCEL" appears on the

display, followed by "

REMOVE MIC", and then the

setup will be cancelled.