A.O. Smith GWV - 120 사용자 설명서
Instruction manual GWV
51
gis
7
The control panel
7.1
Introduction
Topics covered in this chapter:
•
•
•
;
•
;
•
•
7.2
Operation
The entire appliance is controlled and monitored by
the ThermoControl (the electronic control).The figure
shows the electronic controller.
the ThermoControl (the electronic control).The figure
shows the electronic controller.
The control panel is completely menu-driven, and
comprises:
•
comprises:
•
a 4-line display with 20 characters per line;
•
6 pushbuttons for operating the appliance (below
the display);
the display);
•
6 graphical symbols (above the display);
•
a connector for a service PC;
•
an ON/OFF switch.
The pushbuttons are divided into three groups:
•
•
Navigation buttons:
-
-
Buttons for UP , and DOWN ;
-
Enter:
;
-
Reset button:
•
The main menu
•
the service program
This chapter is specifically intended for the service
and maintenance engineer and installation
engineer.
and maintenance engineer and installation
engineer.
In this manual, the display of the electronic controller
is shown as in the figure, both with and without icons.
is shown as in the figure, both with and without icons.
7.3
Meaning of icons
The table explains the meanings of the icons.
Icons and their meaning
7.4
Electronic controller ON/OFF switch
The ON/OFF switch of the electronic controller is used
to switch the appliance ON and OFF.
to switch the appliance ON and OFF.
After switching on, the text INTERNAL CHECK
appears on the display for about 10 seconds. Themain
menu
appears on the display for about 10 seconds. Themain
menu
then appears. If no selection
is made in the main menu, the appliance automatically
switches to the OFF mode
switches to the OFF mode
Note
To isolate the appliance electrically, you must use
To isolate the appliance electrically, you must use
the isolator between the appliance and the mains
power supply.
power supply.
7.5
Navigation buttons
The use of these buttons is explained with the help of
the figure that shows the main menu
the figure that shows the main menu
The navigation buttons are:
•
•
Buttons for UP , and DOWN ;
•
Enter: ;
•
Reset button:
.
GENESIS
IMD-0511 R1
^»START OPERATION
È CHANGE SETPOINT
Tset=70ÉC
Name
Meaning
Heat demand
Heat demand detected
Purge
Pre- and post-purge using
fan
Pressure switch Pressure switch is closed
Glowing
Glowing
(Pre)glow
Gas control
Gas control open/ignition
Flame detection Appliance operational
INTERNAL CHECK
a