A.O. Smith ADM - 40 사용자 설명서

Instruction manual ADM

15

is

Warning
Installation work should be carried out by an approved installation engineer 

in compliance with the general and local regulations imposed by the gas, water 
and power supply companies and the fire service.
The appliance may only be installed in a room that complies with the 
requirements stated in national and local ventilation 
regulations

.

This chapter describes the installation activities to be carried out before the 
appliance may be started up

, in particular:

•

•

•

•

•

•

;

•

;

•

;

•

For a possible conversion to a different gas category, see 
conversion

.

To avoid damaging the appliance, remove the packaging carefully.
We recommend unpacking the appliance at or near its intended location.

Caution
The appliance may only be manoeuvred in an upright position. Take care 

that the appliance is not damaged after unpacking.

Caution
The appliance may not be used in rooms where chemical substances are 

stored or used, due to the risk of explosion and/or corrosion of the appliance. 
Some propellants, bleaching agents, degreasing agents etc. disperse vapours 
which are explosive and/or which cause accelerated corrosion. If the appliance 
is used in a room in which such substances are present, the warranty will be 
void.

ADM appliances are open appliances and may only be installed in an open 
boiler room. Their type is B

11BS

.

The boiler room must be frost-free, or be protected against frost. The table 
shows the environmental conditions that must be adhered to for correct 
functioning of the electronics present in the appliance to be guaranteed.