Hearth & Home Technologies 21M-ACC 사용자 설명서

September 1, 2008

7039-131F

Page  5

R

Consideration must be given to: 
 

•  Safety

 

•  Convenience

 

•  Traffic flow

 

•  Chimney and chimney connector required

It is a good idea to plan your installation on paper, using exact 

measurements for clearances and floor protection, before 

actually beginning the installation.  If you are not using an 

existing chimney, place the appliance where there will be a 

clear passage for a factory-built listed chimney through the 

ceiling and roof.  
We recommend that a qualified building inspector and your 

insurance company representative review your plans before 

and after installation

If this appliance is in an area where children may be near it 

is recommended that you purchase a decorative barrier to go 

in front of the appliance.  Remember to always keep children 

away  while  it  is  operating  and  do  not  let  anyone  operate 

this appliance unless they are familiar with these operating 

instructions.

To provide reasonable fire safety, the following should be 

given serious consideration:

1.  Install  at  least  one  smoke  detector  on  each  floor  of 

your  home  to  ensure  your  safety.    They  should  be 

located  away  from  the  heating  appliance  and  close 

to  the  sleeping  areas.    Follow  the  smoke  detector 

manufacturer’s placement and installation instructions, 

and be sure to maintain regularly.  

2.  A  conveniently  located  Class A  fire  extinguisher 

to  contend  with  small  fires  resulting  from  burning 

embers.

.  A practiced evacuation plan, consisting of at least two 

escape routes.

4.  A plan to deal with a chimney fire as follows:
 

In the event of a chimney fire:
a  Evacuate the house immediately

b.  Notify fire department

•  Do NOT connect this unit to a chimney flue 

servicing another appliance.

•  Do NOT connect to any air distribution duct or 

system.

May allow flue gases to enter the house.

•  Do not operate appliance before reading and 

understanding operating instructions.

•  Failure to operate appliance properly may 

cause a house fire.

•  Installation and use of any damaged appliance. 
•  Modification of the appliance.
•  Installation  other  than  as  instructed  by  Hearth  &  Home 

Technologies.

•  Installation and/or use of any component part not approved 

by Hearth & Home Technologies.

•  Operating  appliance  without  fully  assembling  all 

components.

•  Operating appliance without legs attached (if supplied with 

unit).

•  Do NOT Overfire - If appliance or chimney connector glows, 

you are overfiring.

Fire Risk.
Hearth & Home Technologies disclaims any 

responsibility for, and the warranty will be 

voided by, the following actions: 

Check building codes prior to installation.
•  Installation  MUST  comply  with  local,  regional,  state  and 

national codes and regulations.

•  Consult  insurance  carrier,  local  building,  fire  officials  or 

authorities having jurisdiction about restrictions, installation 

inspection, and permits.

NOTE:  Service Space
In  order  to  replace  the  tube  channel  a  clearance  of  17 

inches  (42mm)  is  required  on  the  right  side  of  stove  in 

order to remove the tubes with the stove in place.  
If space is not available, the stove will have to be discon-

nected from the chimney to proceed with the tube replace-

ment.