Soundstream Technologies Wireless Subwoofer Volume Control System 사용자 설명서
6
INSTALLATION
1.
Disconnect all power wires from the amplifier.
2.
Remove the bottom cover plate of the amplifier by removing the
four screws at the ends of the amplifier. (There also may be
screws on the center of the bottom plate on the larger Reference
amplifiers.) A Torx® T-15 driver will be needed to remove the
screws.
four screws at the ends of the amplifier. (There also may be
screws on the center of the bottom plate on the larger Reference
amplifiers.) A Torx® T-15 driver will be needed to remove the
screws.
3.
With a Philips screw driver, bolt the AIRBASS receiver board to
the four stand-offs on the bottom plate of the amplifier using the
four screws provided.
the four stand-offs on the bottom plate of the amplifier using the
four screws provided.
4.
Plug the ribbon cable to the receiver board and to the amplifier
main pc board connector. The connector will only go on one way.
main pc board connector. The connector will only go on one way.
5.
On the amplifier main pc board near the ribbon connector, there is
a switch labeled "AIRBASS". Move this switch to the "IN" position.
a switch labeled "AIRBASS". Move this switch to the "IN" position.
6.
Route the antenna wire through one of the holes in the bottom
plate.
plate.
7.
Re-attach the bottom cover to the amplifier.
8.
Once in the car, mount the amplifier and route the antenna wire.
For the best range, place the end of the antenna as high up in the
vehicle as possible.
For the best range, place the end of the antenna as high up in the
vehicle as possible.
9.
For multiple receiver boards on multiple amplifiers, route the
antennas as far from each other as possible. This will give the best
range of operation.
antennas as far from each other as possible. This will give the best
range of operation.
10. Please read your amplifier owner's manual to see how AIRBASS
7
BASIC OPERATION
The AIRBASS receiver board comes from the factory pre-programmed
to be used with the transmitter it has been packaged with. The
AIRBASS accessory is operated simply by momentarily depressing any
of the four buttons on the top of the remote controller. For initial
transmitter set-up, please refer to the diagram below and follow these
steps:
1.
Turn on the amplifier.
2.
The AIRBASS accessory comes from the factory programmed to
start in the "maximum" setting (i.e., +24 dB). While in this state,
set the level of the amplifier by adjusting the gain controls on the
front of the amplifier. This level should be the loudest the amplifier
is ever played.
start in the "maximum" setting (i.e., +24 dB). While in this state,
set the level of the amplifier by adjusting the gain controls on the
front of the amplifier. This level should be the loudest the amplifier
is ever played.
3.
Momentarily press the
ê button to decrease the output level. The
LED on the transmitter will light RED for about a second. This will
decrease the level ONE STEP. Wait for the LED to go out before
sending another command.
decrease the level ONE STEP. Wait for the LED to go out before
sending another command.
4.
Momentarily press the
é button to increase the output level.
5.
Momentarily press the "X" button to MUTE the output of the