Phoenix Gold SD1300.1 사용자 설명서

© 2011 Phoenix Gold • www.phoenixgold.com  

Amplifier Owner’s Manual

RMS Power 14.4Vdc ≤1% THD 

80 x 4 @ 4 ohms Stereo

 

125 x 4 @ 2 ohms Stereo

 

250 x 2 @ 4 ohms Bridged

 

 

plus

 

500 x 1 @ 4 ohms

 

800 x 1 @ 2 ohms

 

Dynamic Power 14.4Vdc >1% THD 

95 x 4 @ 4 ohms Stereo

 

150 x 4 @ 2 ohms Stereo

 

300 x 2 @ 4 ohms Bridged

 

 

plus

 

700 x 1 @ 4 ohms

 

1000 x 1 @ 2 ohms

Recommended Fuse Size: 

100 amp

Power/Ground Wire Size: 

4 Gauge

Dimensions (Includes Mounting Feet):           14.33” L x 6.93” W x 2.0” H

 

        364mm L x 176mm W x 51mm H

Dimensions (Includes Terminals):  

        14.96” L x 6.93” W x 2.0” H

 

        380mm L x 176mm W x 51mm H

RMS Power 14.4Vdc ≤ 1% THD  

        900 x 1 @ 2 ohms 

 

        1300 x 1 @ 1 ohm

Dynamic Power 14.4Vdc >1% THD 

        1200 x 1 @ 2 ohms

 

        1600 x 1 @ 1 ohm

Recommended Fuse Size:  

        120 amp

Power/Ground Wire Size:  

        4 Gauge

Dimensions (Includes Mounting Feet):           14.33” L x 6.93” W x 2.0” H

 

        364mm L x 176mm W x 51mm H

Dimensions (Includes Terminals):  

        14.96” L x 6.93” W x 2.0” H

 

        380mm L x 176mm W x 51mm H 

 

INPUT

Connect preamp signal cables from the head unit to these terminals.

CROSSOVER FREQUENCY

Controls the lowpass crossover point for the speaker outputs. 

BASS BOOST

Variable bass boost from 0 to +18dB @ 45Hz. 

REMOTE LEVEL CONTROL

This port is for connecting the subwoofer remote level control. This allows 

up to 20dB of volume adjustment.  This is not a bass boost, it controls the 

level of the low pass signal. 

NOTE: This control is not compatible with the Phoenix Gold LPL44 level 

control.

SENS

Used to reach maximum amplifier power with a wide variety of headunits.

SUBSONIC CROSSOVER FREQUENCY

Controls the highpass crossover point for the speaker outputs to eliminate 

extreme low frequencies.

RMD

Optional RMD Voltage Display plugs into this port. Sold separately.  

+12V 

This must be connected to the fused positive terminal (+12V) of the car’s 

battery. The fuse must be located within 18 inches of the battery. 

REMOTE 

This must be connected to switched +12V, usually a trigger wire coming 

from the head unit or ignition. 

GROUND

 

This must be connected to the negative terminal of the car’s battery or 

bolted to a clean, unpainted part of the chassis of the vehicle.

SPEAKER OUTPUTS

Used to connect the amplifier to speakers. SD1300.1 minimum impedance 

is 1 ohm. 

NOTE: Visible through the plexiglass cover, a single blue power LED is located in the lower corner of all SD amplifiers.