Novatel OM-20000149 사용자 설명서
Installation and Setup
Chapter 2
AG-STAR User Manual Rev 2
16
2.1.4
Mounting the AG-STAR
Mount the AG-STAR on a secure, stable structure capable of safe operation in the specific environment.
•
If installing on a vehicle, mount the AG-STAR on the vehicle roof, ideally close to the pivot point of the
vehicle. The AG-STAR must be mounted with the connector facing the rear of the vehicle (see Figure 6,
AG-STAR Orientation).
vehicle. The AG-STAR must be mounted with the connector facing the rear of the vehicle (see Figure 6,
AG-STAR Orientation).
Figure 6: AG-STAR Orientation
•
If installing in a stationary location, mount the AG-STAR in a location that has a clear view of the sky so
that each satellite above the horizon can be tracked without obstruction. For more information, refer to An
Introduction to GNSS found at
that each satellite above the horizon can be tracked without obstruction. For more information, refer to An
Introduction to GNSS found at
.
2.1.5
Connecting Data Communications Equipment
To communicate with the receiver by sending commands and obtaining logs, a connection to data
communications equipment is required. See Table 7, AG-STAR Communication/Power Cable Pinouts on
page 47 for more information.
communications equipment is required. See Table 7, AG-STAR Communication/Power Cable Pinouts on
page 47 for more information.
The AG-STAR must be rigidly secured to the vehicle to avoid errors caused by vibration and
motion.
motion.
Orient toward the front
of vehicle
Route cable toward
back of vehicle