Shindaiwa X7502825800 사용자 설명서

6

Emission Control Label   (located on Engine)  (EXAMPLE ONLY, information on label varies by FAMILY).

The 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine emissions 

output meets applicable emissions regulations, provided that approved maintenance procedures are followed as listed in 

the Maintenance Section of this manual.

The emission control system for the engine is EM/TWC (Engine Modification and 3-way Catalyst) and for the fuel tank the 

Control System is EVAP (Evaporative Emissions) or N (for nylon tank). Evaporative emission may be applicable to California 

models only.

It may be necessary to pull the flex 

cable out from the shaft tube, engage 

into the gearcase and then slide the 

assembly onto the shaft tube.

Loosen gearcase clamp screw.

1. 

Remove the gearcase index screw.

2. 

Slide gearcase on to shaft tube, 

3. 

engaging flex drive cable with 

female socket in gearcase.  

Align index screw hole in gearcase 

4. 

with index hole in shaft tube, 

and install index screw.  Tighten 

securely.
Tighten the clamp bolt and torque 

5. 

to 5.9 - 8.0 N•m (52 - 69 in•lbs).

Before assembling, make sure you have 

all the components required for a com-

plete unit. Carefully inspect all compo-

nents for damage.

Outer Tube/Main Shaft Assembly

 

■

The terms “left”, “left-hand”, and 

“LH”; “right”, “right-hand”, and “RH”; 

“front” and “rear” refer to directions as 

viewed by the operator during normal 

operation.

Cutting Attachment Shield

 

■

Edger Blade

 

■

Kit containing this owner's/opera-

 

■

tor's manual, and a tool kit for rou-

tine maintenance.