Roland VS-700 사용자 설명서

 

Creating a Performance

 

With the Fantom VS, you have total control over a wide 

variety of settings. Each item that can be set is known as a 

 

. This chapter explains the procedures used in 

creating Performances, and the functions of the Performance 

parameters.

 

Selects the group to which the desired patch or rhythm set 

belongs.

 

 

 

Preset A–I

 

GM (GM2)

 

Selects the desired patch or rhythm set by its number.

 

001–

 

Adjust the volume of each part. This setting’s main purpose is 

to adjust the volume balance between parts.

 

 0–127

 

Adjust the pan of each part. “L64” is far left, “0” is center, and 

“63R” is far right.

 

 L64–0–63R

 

Select one part whose sound you want to play. Turn it “SOLO” 

to the part that you want to solo. Parts other than the part 

you select here will not sound.

 

 –, 

SOLO

 

Mutes (MUTE) or un-mutes (OFF) each part.

 

 OFF, 

MUTE

 

The Mute Switch parameter does not turn the part off, 

but sets the volume to minimum so that no sound is 

heard. Therefore, MIDI messages are still received.

 

Adjusts the pitch of the part’s sound up or down in units of 

an octave (+/-3 octaves).

 

 -3– 

+3

 

Note that when a rhythm set is assigned to a part, you 

cannot modify the Octave Shift parameter.

 

Adjusts the pitch of the part’s sound up or down in semitone 

steps (+/-4 octaves).

 

 -48– 

+48

 

Adjusting the Parameters of 
Each Part

 

 Parameter List

The Coarse Tune and Fine Tune parameters, along with 

the Octave Shift parameter, can all be seen as doing the 

same thing to the sound, i.e., changing the pitch of the 

sound. For example, if C4 (Middle C) is played with the 

Coarse Tune parameter set to “+12,” the note produced 

is C5 (one octave above C4). For example, if C4 (Middle 

C) is played with the Octave Shift parameter set to “+1,” 

the note produced is C5 (one octave above C4).

However, internally these function very differently. 

When the Coarse Tune parameter is set to “+12,” the 

pitch itself is raised one octave. On the other hand, 

when the Octave Shift parameter is set to “+1,” it is the 

same as pressing the keys one octave up. In other 

words, use the Coarse Tune parameter when changing 

the pitch, and the Octave Shift parameter when you 

want to shift the entire keyboard, for example, when the 

number of keys is insufficient.

VS-700_r_e.book 136 ページ ２００８年１１月２０日　木曜日　午後２時２８分