Siemens 350 사용자 설명서

Safety instructions

These Operating Instructions contain information which you should observe to ensure your own personal safety

as well as to protect the product and connected equipment. The notices referring to your personal safety are

highlighted in the manual by a safety alert symbol. Notices referring only to equipment damage have no safety

alert symbol. Warnings are shown in descending order according to the degree of danger as follows.

DANGER

indicates that death or serious injury will result if proper precautions are not taken.

WARNING

indicates that death or serious physical injury may result if proper precautions are not taken.

CAUTION

with a safety alert symbol indicates that minor personal injury can result if proper precautions are not taken.

CAUTION

without a safety alert symbol indicates that damage to property may result if proper precautions are not taken.

CAUTION

indicates that an unwanted result or state may occur if the relevant instruction is not observed.

In the event of a number of levels of danger prevailing simultaneously, the warning corresponding to the highest

level of danger is always used. A warning that uses a safety alert symbol indicating possible personal injury may

also include a warning relating to material damage.

Qualified personnel

The associated equipment / system may only be set up and operated in conjunction with this documentation. The

equipment / system may only be commissioned and operated by qualified personnel. For the purpose of the

safety information in these Operating Instructions, a "qualified person" is someone who is authorized to energize,

ground, and tag equipment, systems, and circuits in accordance with established safety procedures.

Proper handling

Note the following:

WARNING

The equipment may only be used for single-purpose applications explicitly described in the catalog and in the

technical description, and only in conjunction with third-party devices and components approved by Siemens.

This product can only function correctly and safely if it is transported, stored, set up, and installed correctly, and

operated and maintained as recommended.

Trademarks

All names shown with the trademark symbol ® are registered trademarks of Siemens AG. Third parties using for

their own purposes any other names in this document which refer to trademarks might infringe upon the rights of

the trademark owners.

Disclaimer of liability

We have checked that the contents of this document correspond to the hardware and software described.

However, since deviations cannot be precluded entirely, we cannot guarantee full consistency. The information

given in this publication is reviewed at regular intervals and any corrections that might be necessary are made in

the subsequent editions.

Siemens AG

A5E
Ⓟ 12/2009