Jacuzzi J - 345 사용자 설명서

다운로드
페이지 72
Attention New Spa Owner!
Congratulations on the purchase of your new Jacuzzi® spa! The following is a 
list of automated functions performed by your spa. These functions are listed 
below in an attempt to alleviate any operational concerns you may have during 
the first 24 hours of ownership! Also listed below are important maintenance 
recommendations you should observe on a regular basis to protect your new 
investment.
Automated Operations
Approximately two minutes after power is applied to the spa, the first filtration/
heating cycle turns on pump 1. An automatic “blow-out” function also activates 
pump 2 (if equipped) for a period of one minute to flush all lines. Then, after one 
minute, pump 2 turns off and pump 1 continues to operate for the duration of the 
cycle.
Note: This function only occurs during the first filtration/heating cycle each day.
Maintain Healthy Spa Water
Always maintain your spa’s water chemistry within the following parameters:
With CLEARRAY®
Without CLEARRAY®
pH
7.4-7.6
7.4-7.6
Free Chlorine
no less than 1.0 ppm
3.0-4.0 ppm
Free Bromine
no less than 2.0 ppm
2.0-4.0 ppm
Total Alkalinity
100-120 ppm
100-120 ppm
Calcium Hardness
150-250 ppm
150-250 ppm
IMPORTANT: CLEARRAY® Water Purification System is factory installed. If 
the CLEAR
RAY® system is altered or is not operating efficiently then follow 
the “without CLEAR
RAY®” water chemistry parameters as defined by the 
Association of Pool and Spa Professionals. CLEAR
RAY® requires an annual 
bulb replacement to properly sanitize your water.
!  
TO DECREASE RISK OF INFECTION OR DISEASE! Always maintain 
your spas filter as outlined below to ensure healthy spa water. Refer page 43 
“Water Quality Maintenance” for additional information.
Required Filter Maintenance
Your new spa is equipped with an advanced water filtration system that provides 
unsurpassed water quality! To ensure maximum water quality at all times, you 
should clean both filter cartridges every month, or earlier as necessary. See page 
Required Water Replacement
!
 
TO DECREASE RISK OF INFECTION OR DISEASE! You should replace 
the spa’s water every 3 months. The frequency depends on a number of variables 
including frequency of use, number of users, and attention paid to water quality 
maintenance. You will know it is time for a change when you cannot control 
sudsing and/or you can no longer get the normal feel or sparkle to the water, 
even though the key water balance measurements are all within the proper 
©Jacuzzi Hot Tubs. All Rights Reserved