Generac 005413-0 사용자 설명서

 

 Never operate the generator while the vehicle 

is parked over high grass, weeds, brush, 

leaves or any other combustible substance. 

Such materials can ignite and burn from the 

heat of the exhaust system. The generator 

exhaust system becomes extremely hot dur-

ing operation and remains hot for a long time 

after it has shut down.

For oil capacities and requirements, see the “Engine Oil 

Requirements” section. Check the engine crankcase oil level at 

least every eight hours of operation, or before it is used. To check 

the engine oil level, proceed as follows (see Figure 3.1):
1.  Be sure the generator is as level as possible.
2.  Remove the dipstick and wipe it dry with a clean, lint-free 

cloth.

3.  Install and tighten the dipstick cap; then, remove it again. The 

oil level should be at the dipstick “Full” mark.

4.  If necessary, remove the oil fill cap on the rocker cover and 

slowly add oil until it reaches the dipstick “Full” mark. DO NOT 

FILL ABOVE THE “FULL” MARK.

n

 

 Never operate the engine with the oil level 

below the “Add” mark on the dipstick. Doing 

this could damage the engine.

5.  Install and tighten the oil fill cap and the dipstick before oper-

ating the engine.

n

 

 Hot oil may cause burns. Allow engine to 

cool before draining oil. Avoid prolonged 

or repeated skin exposure with used oil. 

Thoroughly wash exposed areas with soap.

Oil Change Intervals – see Section “RV Generator Service 

Interval”.
To change the oil and oil filter, proceed as follows:
1.  Run the engine until it is thoroughly warmed up (at least five 

minutes) then shut off the engine.

2.  With the engine still warm from running, remove the round 

access grommet from underneath the front of the generator. 

Place a suitable container underneath to catch all the drain 

oil.

3.  Use the 0G4818 tool (supplied with the generator) to turn the 

old filter counter-clockwise and remove. Let oil drain into the 

container located directly below.

4.  Locate the oil drain hose inside and pull the yellow drain plug 

out of the access hole (Figure 3.1).

5.  Turn the yellow cap counter-clockwise to remove and finish 

draining the old oil.

6.  After the oil has been drained, replace the oil drain plug by 

tightening it clockwise and return.

7.  Clean off the oil filter bracket and any old oil that may have 

spilled while draining.

8.  Apply a light coating of clean engine oil the gasket of the new 

oil filter (Figure 3.2).

9.  Screw the new oil filter on by hand until its gasket lightly con-

tacts the oil filter adapter. Then, tighten the filter an additional 

¾ to one turn. Replace and secure the round access grom-

met.

Maintenance