Datalogic Scanning F725-E Series 사용자 설명서

F725-E SERIES TERMINALS 

   

 

 
 

Rechargeable battery packs (NiCd/NiMh) are not 
initially charged. Therefore the first operation to 
perform is to charge them in the appropriate 
cradle. See chapter 2 and the following 
paragraph "Charging the Batteries". 

 
 

 
Battery charge life depends on many variables but, under normal 
conditions, autonomy is more than enough for a day work. 
 
Information on the battery-charge status is provided by the 
dedicated icon on the display 

. The information provided by the 

icon is valid only when the terminal is not inserted in the cradle. 
Four different charge levels are given from a maximum value (all 
the icon segments full) to a minimum one which warns of pre-low-
battery (icon empty and intermittently flashing). 
 
Recharging should be made after using the terminal until the 
batteries are nearly flat. 
 
 

 
 
Recharge the terminal by simply inserting it into its cradle; 
Datalogic S.p.A. recommends a minimum uninterrupted recharging 
time of eight hours. When using the NiMh battery a standard 
recharge does not allow taking fully advantage of the improved 
battery technology. For this reason, a recharging time of about 60 
hours is advised to get the NiMh maximum capacity. 
 
When batteries are new, or have not been recharged for a long 
time, it is necessary to perform two or three charge and discharge 
cycles (with complete use) before the batteries are able to reach 
their maximum capacity.