Datalogic Scanning QD2100 사용자 설명서

Data Editing

Character conversion is an eight byte configuration item. The eight bytes are 4 character 
pairs represented in hexadecimal ASCII values. The first character in the pair is the char-
acter that will be converted. The second character in the pair is the character to convert 
to. If the character to convert in a pair is FF, then no conversion is done.

For example, if you have the character conversion configuration item set to the following: 
41423132FFFFFFFF

The first pair is 4142 or AB (41 hex is an ASCII capital A, 42 hex is an ASCII capital B) 
and the second pair is 3132 or 12 (31 hex is an ASCII 1, 32 is an ASCII 2). The other 
two pairs are FFFF and FFFF.

With the label, AB12BA21, it would look as follows after the character
conversion: BB22BB22.

The A characters were converted to B characters and the 1 characters were converted to 
2 characters. Nothing is done with the last two character pairs, since they are all FF.

To set Character Conversion:

1. Scan the ENTER/EXIT barcode.

2. Scan the “Configure Character Conversion” barcode.

3. Determine the desired string. Sixteen positions must be determined as in the above exam-

ple. Next, turn to the ASCII Chart on the inside back cover of this manual and find the 
equivalent hex digits needed to fulfill the string.

4. Turn to 

Appendix E, Keypad

 and scan the barcodes representing the hex characters 

determined in the previous step.

5. Scan the ENTER/EXIT barcode to exit Programming Mode.