Datalogic Scanning QD2100 사용자 설명서

Label Gone Timeout

This feature sets the time after the last label segment is seen before the reader prepares for 
a new label. The timeout can be set within a range of 10 milliseconds to 2,550 millisec-
onds (2.55 seconds) in 10ms increments. Label Gone Timeout does not apply to scan 
modes that require a trigger pull for each label that is read

Follow these instructions to set this feature:

1. Determine the desired setting in milliseconds.

2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with lead-

ing zeroes to yield three digits. For example: 0 = 000, 5 = 005, 20 = 020, etc.

3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming 

Mode.

4. Scan the barcode: SELECT LABEL GONE TIMEOUT SETTING.

5. Scan the appropriate three alpha-numeric characters from the keypad in 

Appendix E, Key-

pad

 representing the duration which was determined in the steps above. You will hear a 

two-beep indication after the last character.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming 

Mode.

This completes the procedure. See 

Table 2

 for some examples of how to set this feature.

50ms

150ms

1800ms (1.8 sec.)

2550ms (2.55 sec.)

005

015

180

255

Appendix E, Keypad

‘0’, ‘0’ and ‘5’

‘0’, ‘1’ and ‘5’

‘1’, ‘8’ and ‘0’

‘‘2’, ‘5’ and ‘5’