Kodak ESP 3260 사용자 설명서

다운로드
페이지 56
Product and Safety Specifications
44
www.kodak.com/go/aiosupport
Regulatory compliance
FCC statement
The United states Federal Communications Commission (in CFR 47 Part 15.105) has 
specified that the following notice be brought to the attention of the users of this 
product:
Note: This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed 
to provide reasonable protection against harmful interference in a residential 
installation. This equipment generates, uses, and can radiate radio frequency energy 
and, if not installed and used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause 
harmful interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver
• Connect the product into an outlet on a circuit different from that to which the 
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Pursuant to Part 15.21 of the FCC Rules, any changes or modifications to this 
product not expressly approved by Eastman Kodak Company might cause 
harmful interference and void the FCC authorization to operate this product.
The radiated energy from this product is well below the FCC radio frequency 
exposure limits. Nevertheless, the product shall be used in such a manner 
that the potential for human contact during normal operation is minimized. 
This product and any attached external antenna, if supported, shall be placed 
in such a manner to minimize the potential for human contact during normal 
operation. In order to avoid the possibility of exceeding the FCC exposure 
limits, human proximity shall not be less than 20 cm (8 inches) during normal 
operation.
Canadian 
statements
This product meets the applicable Industry Canada technical specifications.
Operation is subject to the following two conditions: (1) this device may not cause 
interference, and (2) this device must accept any interference, including interference 
that may cause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.