Panasonic KX-PS8000 사용자 설명서
47
Setup
Connecting the Scanner to a Computer
Note for Terminator setting:
B
The terminator must be installed or set to ON on the last SCSI device only.
Make sure the computer, scanner and the other connected
peripheral devices are turned off.
peripheral devices are turned off.
Connect the SCSI cable to the computer’s SCSI connector and to
the scanner’s SCSI connector A or B.
the scanner’s SCSI connector A or B.
B
The SCSI-2 board must be installed in the computer.
If you do not have a SCSI-2 board or a SCSI interface cable, you will need to
purchase one from your local computer store or dealer
If you do not have a SCSI-2 board or a SCSI interface cable, you will need to
purchase one from your local computer store or dealer
B
If other SCSI devices are connected to the computer, connect the scanner
anywhere in the SCSI chain.
anywhere in the SCSI chain.
Make sure the SCSI ID No. of the scanner is 2 (default setting).
B
If other devices are connected to the computer, make sure that each SCSI
device has a different ID No.
device has a different ID No.
B
To change the scanner’s ID No., use the ID No. switches (#1, #2, #3)
located on the back of the scanner. Also refer to Table 1 on
located on the back of the scanner. Also refer to Table 1 on
1
2
3
1
2
3
4
ON
Computer’s
SCSI connector
SCSI connector