Nortel Networks 311 사용자 설명서
280
NT5D33 and NT5D34 Lineside E1 Interface cards
Characteristic
Selection
Switch
Position
Switch
Setting
Factory
Default
Line processing on E1 link
failure
failure
On-hook
Off-hook
6
ON
OFF
OFF
Daisy-chaining to MMI
YES
NO
7
ON
OFF
OFF
MMI master or slave
Master
Slave
8
ON
OFF
ON
After the card has been installed, display the dip switch settings using
the MMI command Display Configuration (D C). See
the MMI command Display Configuration (D C). See
for details on this and the rest
of the available MMI commands.
Installation
Because of the wiring in some of the system modules and cabinets, the LEI
only works in certain card slot pairs. These restrictions depend on the type
of module or cabinet. In all other modules or cabinets where the conditions
listed below do not exist, the LEI works in any two adjacent card slots:
only works in certain card slot pairs. These restrictions depend on the type
of module or cabinet. In all other modules or cabinets where the conditions
listed below do not exist, the LEI works in any two adjacent card slots:
•
In the NTAK12 Small Remote IPE Expansion Cabinet only card slots
10-15 are available.
10-15 are available.
•
In the NT8D37 IPE module, if the 25-pair I/O connectors are partially
split between adjacent IPE card slots, the LEI works only in card slots
where Unit 0 of the motherboard card slot appear on the first pair of
the 25-pair I/O connector.
split between adjacent IPE card slots, the LEI works only in card slots
where Unit 0 of the motherboard card slot appear on the first pair of
the 25-pair I/O connector.
If installing the LEI into the NT8D37 IPE module, determine the vintage level
model. Certain vintage levels carry dedicated 25-pair I/O connectors only
for card slots 0, 4, 8, and 12. These vintage levels are cabled with only 16
pairs of wires from each card slot to the I/O panel. Some of the 25-pair I/O
connectors are split between adjacent card slots.
model. Certain vintage levels carry dedicated 25-pair I/O connectors only
for card slots 0, 4, 8, and 12. These vintage levels are cabled with only 16
pairs of wires from each card slot to the I/O panel. Some of the 25-pair I/O
connectors are split between adjacent card slots.
Other vintage levels cable each card slot to the I/O panel using a unique,
24-pair connector on the I/O panel. In these vintage levels, the LEI can be
installed in any available pair of card slots. However, because of the lower
number of wire pairs cabled to the I/O panel in the lower vintage level, only
certain card slots are available to the LEI.
24-pair connector on the I/O panel. In these vintage levels, the LEI can be
installed in any available pair of card slots. However, because of the lower
number of wire pairs cabled to the I/O panel in the lower vintage level, only
certain card slots are available to the LEI.
See
for the vintage level information for the NT8D37 IPE modules.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311
01.04
Standard
Release 5.0
23 May 2008
Copyright © 2003-2008, Nortel Networks
.