Nortel Networks 311 사용자 설명서

302

NT5D33 and NT5D34 Lineside E1 Interface cards

Figure 66
Set Simple (S S) no screen

Figure 67
Set Simple (S S) yes screen

Set Mode

At the

SET MODE (S M)

command, the MMI prompts the user with the

current signaling mode, either Default (Australian P2) or Table (of bit values.)
Entering a

<CR>

accepts the current value, or the user can type in 1 to

revert to the Default, or 2 to edit the table entries. See

. If the user selects default, then the A/B Bit values is

reset to the Default values.

Responding to the MMI’s Set Mode prompt with "1" also results in the
line, "Signaling Bits set to Default," as in

Figure 68
Set Mode screen

However, responding to this prompt with 2 selects "Table" and allows the
user to set the A/B Bit Mode to whatever configuration the user chooses.

If "Table" is selected, the individual table values are prompted for. See

and

. After each value is displayed, enter

<CR>

to do the following:

•

accept the current value

Nortel Communication Server 1000

Circuit Card Reference

NN43001-311

01.04

Standard

Release 5.0

23 May 2008